 |
How to use NameStamp
How to use NameStamp 1. Press stamp gently a few times onto the inkpad to ink the stamp. Do NOT press too hard onto the stamp pad. Check if the ink is spread evenly on the stamp.
2. Press firmly but not excessively onto a hard / flat surface. Keep the stamp straight upright and do not roll as you press down or pull up. Please practice at least a few times on a similar unwanted fabric or paper before you actually stamp onto clothes.
3. If you need to re-ink the pad at some stage in the future then put 10 drops of ink onto the inkpad evenly ensuring you also cover the edges. Wait for 15 mins until the ink sinks into inkpad.
The key to a sharp image is to evenly spread appropriate amount of ink on the stamp. If the image is blurry or light just simply practice a little.
Please see the video clip below for more details
Important NOTE
· Please place unwanted news paper, etc under the stamp pad and ink bottles before you put the ink onto the stamp pad as don’t forget the ink is permanent.
· Please do not put more than 10 drops of ink on the inkpad at one time. You cannot use the inkpad if it is over inked.
· Please do NOT allow children to touch the stamps, ink and cleaning solution. The ink is permanent.
· Please do not press stamp too hard on the ink pad as image will end up blurred.
· Please do NOT stamp on wet surface
Advanced Stamping
On a flat plastic surface (such as a lunch container)
Make sure the ink is spread evenly on the stamp.
Press very gently onto the plastic surface. Please do not press hard.
If you make any mistakes, please use the Cleaning Solution to remove and try again. Cleaning Solution
will only work on a hard shiny surface.
On a round surface (such as a pen or a round container, etc)
Make sure the ink is spread evenly on the stamp. This is the most important point.
Press gently onto the surface with a rolling action.
This may need practice. I recommend trying on shiny surface goods to start so that you can wipe it off if
you make any mistakes.
|
